Paradyne COMSPHERE 3830 User Manual page 80

COMSPHERE 3800 Series Modems – Model 3830
S69 Make Busy Via DTR
Determines if the modem goes off-hook (busy) when DTR is Off.
Register has the following values:
0 = Disable
1 = Enable
Factory setting is Disable.
S74 Network Position Identification
Register identifies each modem as either a control or tributary modem.
Register has the following values:
0 = Tributary
1 = Control
Factory setting is Tributary.
S75 Network Management Address
Register determines the modem's network address. This address is used
when accessing the modem from the NMS.
Enter a value from 0 (network address 001) to 255 (network address
256).
Factory setting is 255.
S76 V.32bis Autorate (Dial Line)
Determines if the Autorate function is used on dial lines when connected
in V.32bis mode. Autorate allows the modem to adjust line speed due to
noise.
Register has the following values:
0 = Enable
1 = Disable
2 = Start at 4800 bps
3 = Start at 9600 bps
Factory setting is Enable.
4-44
Table 4-3
(15 of 20)
Model 3830 S-Registers
August 1998 3830-A2-GB91-30