Paradyne COMSPHERE 3830 User Manual page 65

%Cn MNP5 Data Compression
Determines if the modem uses MNP Class 5 data compression. It can be
set independently of V.42bis data compression. Online changes do not
take effect until a disconnect occurs.
%C0 Disable.
%C1 Enable.
%Rn DTE Rate
Sets the rate at which data is passed between the modem and the DTE.
%R must be the last command on the command line. Setting the DTE
rate with the %R command does not turn off autobauding.
%R115200 Sets the DTE rate to 115,200 bps.
%R76800 Sets the DTE rate to 76,800 bps.
%R57600 Sets the DTE rate to 57,600 bps.
%R38400 Sets the DTE rate to 38,400 bps.
%R19200 Sets the DTE rate to 19,200 bps.
%R14400 Sets the DTE rate to 14,400 bps.
%R9600 Sets the DTE rate to 9600 bps.
%R7200 Sets the DTE rate to 7200 bps.
%R4800 Sets the DTE rate to 4800 bps.
%R2400 Sets the DTE rate to 2400 bps.
%R1200 Sets the DTE rate to 1200 bps.
%R300 Sets the DTE rate to 300 bps.
H n V.42bis Compression
Enables or disables V.42bis data compression.
H0 Disable.
H1 Transmit only.
H2 Receive only.
H3 Enable.
3830-A2-GB91-30
Table 4-2
(23 of 23)
Model 3830 AT Commands
August 1998
4. AT Command Set and S-Registers
4-29