S91
Cellular Enhancements
Valid only if Enhanced Throughput Cellular (ETC) is installed. Register
determines whether parameters are set to improve performance over a
cellular link. Should be enabled when the remote modem is using a
cellular connection.
Register has the following values:
0 = Disable
1 = Enable
Factory setting is Disable; &F5 and &F6 set S91 to Enable.
S93
RJ11 Cellular Adapt
Valid only if Enhanced Throughput Cellular (ETC) is installed. Register
controls support for an RJ11 connection, including generation of the ETC
1.1 Calling Tone during call origination.
0 = Disable
1 = Enable
Factory setting is Disable.
3830-A2-GB91-30
Table 4-3
(20 of 20)
Model 3830 S-Registers
August 1998
4. AT Command Set and S-Registers
4-49