Paradyne COMSPHERE 3830 User Manual page 67

S2 AT Escape Character
Determines ASCII value used for escape sequence to enter Command
mode from Data mode.
Enter a value from 0 to 127 for the escape character. Any value greater
than 127 causes the modem to disable the escape sequence. When the
escape sequence is disabled, the modem cannot return to Command
mode until the call is disconnected.
Factory setting is 43 (ASCII + sign).
S3 Carriage Return Character
Determines ASCII value used as the carriage return (Enter key). This
character is used to end command lines and result codes.
Enter a value from 0 to 127 for the command end character.
Factory setting is 13 (ASCII carriage return).
NOTE: The &W command used to save this change must be on a
separate line. This ensures both that the change is intentional, and that
the DTE can enter the new character.
S4 Line Feed Character
Determines ASCII value used as the line feed character.
Enter a value from 0–127 for the line feed character.
Factory setting is 10 (ASCII line feed).
S5 Backspace Character
Determines ASCII value used as the backspace (Backspace key). This
character moves the cursor to the left and erases the previous character.
Enter a value from 0–127.
Factory setting is 08 (ASCII backspace).
3830-A2-GB91-30
Table 4-3
(2 of 20)
Model 3830 S-Registers
August 1998
4. AT Command Set and S-Registers
4-31