Paradyne COMSPHERE 3800PLUS User Manual page 99

Send Break Cntl: Data-First
Nxt Data-First Break-First
This configuration option only appears when Async/Sync Mode is configured for Async.
Send Break Control. Determines what is sent from the modem first, data or break if a break sequence is sent from the
DTE.
Data First (Nonexpedited) – A break is treated as a data character and is sent in the order it was received. This is also
known as Nonexpedited mode.
Break First (Expedited) – A break is sent before the data currently in the buffer. This is also known as Expedited mode.
The factory default is Data First.
NOTE: This configuration option is ignored if the Break Forces Escape configuration option (see DTE Dialer
configuration options group) is enabled.
AT command equivalent is \K n .
TXBuffDiscDelay: 10sec
Nxt 10sec 60sec Disable
This configuration option only appears when Async/Sync Mode is configured for Async, and Error Control
Mode is not configured for DirectMode, or when Async/Sync Mode is configured for Sync and Sync Comp Mode
is not configured for DirectMode.
The Transmit Buffer Disconnect Delay is the maximum amount of time the modem can continue to send data in its
Transmit Buffer to the remote modem after it is commanded by the DTE to disconnect. Disable means that the
disconnect occurs immediately. The default is 10 seconds.
Disable – Modem disconnects immediately without attempting to send data stored in its buffers.
10, 60 sec – Maximum amount of time the modem tries to empty its buffers before disconnecting. In both cases (10 sec
and 60 sec), the modem disconnects much sooner if it can empty its buffers.
NOTE: This configuration option is not available if Error Control Mode configuration option is set for DirectMode.
AT command equivalent is S-register S49= n.
RxBuffDiscDelay: Disable
Nxt 10sec 60sec Disable
This configuration option only appears when Async/Sync Mode is configured for Async, and Error Control
Mode is not configured for DirectMode, or when Async/Sync Mode is configured for Sync and Sync Comp Mode
is not configured for DirectMode.
Receive Buffer Disconnect Delay. Determines the maximum amount of time the modem can continue to send data in its
Receive Buffer to the DTE after the modem is commanded by the DTE to disconnect, or after the modem detects a line
disconnect. Through the DCP the available settings are Disable, 10sec, and 60sec; Disable means that the disconnect
occurs immediately. The default is Disable.
Disable – Modem disconnects immediately without attempting to send data stored in its buffers.
10, 60 sec – Maximum amount of time the modem tries to empty its buffers before disconnecting. In both cases (10 sec
and 60 sec), the modem disconnects much sooner if it can empty its buffers.
NOTE: This configuration option is not available if Error Control Mode configuration option is set for DirectMode.
AT command equivalent is S-register S39= n .
3980-A2-GB30-40
Table 8-6
(7 of 8)
V.42/MNP/Buffer Configuration Options
October 1998
Configure Branch
8-39