Paradyne COMSPHERE 3800PLUS User Manual page 144

COMSPHERE 3800Plus Modems
AT Command
&I Dial Transmit Level
When Dial Transmit Level Type is set to Permissive, &I n sets Dial Transmit
Level to a value between –10 and –32 dBm. &I99 and &I100 are available
only if Enhanced Throughput Cellular (ETC) is installed and cause the
level to be varied automatically according to conditions for ETC operation.
&I10 –10 dBm
&I11 –11 dBm
S
S
&I32 –32 dBm
&I99 Automatically adjusted according to the ETC1.0 specification. Use
only with remote modems set to &I99, and limit the data rate to
4800 bps (S41=5). Set by &F6.
&I100 Automatically adjusted according to the ETC1.1 specification.
NOTE: &J0 overrides this command; &I n overrides the &J0 command.
&J n
Dial Transmit Level Type
&J0 Permissive (Approx. – 9 dBm).
NOTE: &J0 overrides the &I n command; &I n overrides the
&L n Leased Mode
&L0 Disables leased-line operation.
&L1 2-wire originate leased-line operation.
&L2 4-wire originate leased-line operation.
&L3 2-wire answer leased-line operation.
&L4 4-wire answer leased-line operation.
The &L command will cause the modem to reset before entering or exiting
Leased-Line mode. Therefore, it must be entered as the last command in
an initialization string. The modem must be in Sync Leased mode (&F2 or
&F4) for the &L command to work.
13-10
Table 13-1
3800 Plus AT Commands
Description
S
S
&J0 command.
(8 of 15)
October 1998
Front Panel Branch
Configure\Edit\Dial Line
Configure\Edit\Dial Line
Configure\Edit\
Leased Line
3980-A2-GB30-40