Paradyne COMSPHERE 3800PLUS User Manual page 147

AT Command
\A n
Error Control Maximum Frame Size
\A0 64
\A1 128
\A2 192
\A3 256
\A4 32
\A5 16
\C n
Error Control Negotiate Buffer
\C0 Disable.
\C1 Enable.
\C2 Disables and switches modem to Buffer mode.
\D n CTS Control
\D0 Forced On. Forces CTS to always ON.
\D1 Standard RS232.
\D2 Wink When Disconnect. CTS is turned Off for 1 to 2 seconds upon
a disconnect.
\D3 Follows DTR. The state of CTS follows the state of DTR.
\G n Modem to Modem Flow Control
\G0 Disable.
\G1 Enable.
\K n
Break Buffer Control, Send Break Control, Break Forces Escape
\N n Error Control Mode
\N0 Buffer Mode.
\N1 Direct Mode.
\N2 MNP or Disconnect.
\N3 MNP or Buffer.
\N4 V.42/MNP or Disconnect.
\N5 V.42/MNP or Buffer.
\N6 LAPM or Disconnect.
\N7 LAPM or Buffer.
3980-A2-GB30-40
Table 13-1
(11 of 15)
3800 Plus AT Commands
Description
Break Send
Buffer Break
Control Control
\K0 Discard Data Break First
\K1 Discard Data Break First
\K2 Keep Data Break First
\K3 Keep Data Break First
\K4 Keep Data Data First
\K5 Keep Data Data First
\K6 Discard Break Not Applic.
October 1998
AT Command Set and S-Registers
Front Panel Branch
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
DTE Interface
Configure\Edit\
V42/MNP/Buffer
Break Buffer Control:
Configure\Edit\
V42/MNP/Buffer
Break
Send Break Control:
Forces
Configure\Edit\
Escape
V42/MNP/Buffer
Enable
Break Forces Escape:
Disable
Configure\Edit\
Enable
DTE Dialer
Disable
Enable
Disable
Disable
Configure\Edit\
V42/MNP/Buffer
13-13