Paradyne COMSPHERE 3800PLUS User Manual page 139

Paradyne comsphere modems user's guide 3800plus
Hide thumbs Also See for COMSPHERE 3800PLUS:
Table of Contents

Advertisement

AT Command
DS= n
Dial Stored Number
Dials the number stored in Location n (1–10). (To store a telephone
number, refer to the &Z n=x command.)
If any character is received from the DTE before the modem goes online,
the dial sequence is aborted. This is known as any-key abort.
E n
Command Character Echo
E0
Disables echo to the DTE.
E1
Enables echo to the DTE.
H n
Hook Switch Control
H0
Modem goes on-hook.
H1
Modem goes off-hook.
I n
Identification
I0
Displays product code; default is 144.
Displays 3-digit firmware revision number.
I1
I2
Performs an EPROM check.
I3
Displays the modem's serial number.
Displays the modem's model number. The model number of a
I4
3810 Plus begins with 3980. The model number of a 3811 Plus
begins with 3981.
I5
Displays the part number of the circuit card.
I6
Displays the firmware release number.
Displays 3-digit firmware revision number (same as I1).
I9
I10= n Changes the value of the product code displayed by the
I0 command; n is a number from 0 to 4:
I10=0 sets product code to 144
I10=1 sets product code to 240
I10=2 sets product code to 480
I10=3 sets product code to 960
I10=4 sets product code to 120
I11
Performs a checksum of the modem's firmware and displays the
results in hexadecimal. (There is no DCP equivalent of this
command.)
I19
Displays the entire firmware revision level.
L n
Speaker Volume
L0
Selects low volume.
L1
Selects low volume.
L2
Selects medium volume
L3
Selects high volume.
M n
Speaker On/Off
M0
Speaker always off.
M1
Speaker on until carrier signal is detected.
M2
Speaker always on.
O
Return to Online or Data Mode
Returns modem to Data mode from Online Command mode.
3980-A2-GB30-40
Table 13-1
(3 of 15)
3800 Plus AT Commands
Description
October 1998
AT Command Set and S-Registers
Front Panel Branch
Call Setup\Dial\
Dial Directory:
Configure\Edit\
DTE Dialer
H0: Call
Setup\Disconnect
or
Control\Remove Make
Busy
H1: Control\ Make Busy
Status\Identity
Control\Speaker
Configure\Edit\Misc
Control\Speaker
Configure\Edit\Misc
None
13-5

Advertisement

Table of Contents
loading

Table of Contents