Paradyne COMSPHERE 3800PLUS User Manual page 141

AT Command
X n
Extended Result Code, Dial Tone Detect, and Busy Tone Detect
Configuration Options
Extended Result Code
Enable. Displays all result codes listed in Appendix B except for error
Disable. Only displays OK, CONNECT, RING, NO CARRIER, ERROR.
Add/EC. Displays result codes with /EC suffix. Add/V42,MNP. Displays
Add/V42,MNP. Displays result codes with either V.42 or MNP suffix.
Use DTE Rate. Displays DTE data rate instead of line rate.
Dial Tone Detect
Enable. Sets the modem for dial tone detect.
Disable. Sets the modem for blind dialing.
Busy Tone Detect
Enable. Modem monitors for busy tone.
Disable. Modem ignores busy tone.
Y n Long Space Disconnect
Y0 Disable. Ignores long space.
Y1 Enable. Disconnects if long space is detected. Enables
transmission of a long space.
Z n Reset and Load Active
Z0 Loads configuration options from Active (Saved) to Active
(Operating).
Z1 Loads configuration options from Customer 1 to Active (Operating).
Z2 Loads configuration from Customer 2 to Active (Operating).
Z3 Loads configuration options from Active (Saved) to Active
(Operating) and performs a reset (if the modem is connected, it is
disconnected).
Z9 Performs a full modem reset, as if the power were turned off and
on.
3980-A2-GB30-40
Table 13-1
3800 Plus AT Commands
Description
Extended
Result Code
X0 Disable
X1 Enable
X2 Enable
X3 Enable
X4 Enable
X5 Add/EC
X6 Add/V42,MNP
X7 Use DTE Rate
control suffix.
result codes with either V.42 or MNP suffix. Use DTE Rate.
Displays DTE data rate instead of line rate.
October 1998
(5 of 15)
Dial Busy
Tone Tone
Detect Detect
Disable Disable
Disable Disable
Enable Disable
Disable Enable
Enable Enable
Enable Enable
Enable Enable
Enable Enable
AT Command Set and S-Registers
Front Panel Branch
Extended Result Code:
Configure\Edit\DTE Dialer
Dial Tone Detect:
Configure\Edit\
Line Dialer
Busy Tone Detect:
Configure\Edit\
Line Dialer
Configure\Edit\
Line Dialer
Control\Reset
13-7