Table of Contents
Advertisement
INSTRUMENT PANEL
SOUND BUTTON SCROLL ORDER
When you repeatedly press the SOUND
button, the functions will scroll in the fol-
lowing order: BASS, TRE, BAL, FADE, EQ
OFF, and VOL.
SOUND button (6):
Setting the Tone (Bass/Treble)
Press the SOUND button until "BAS"
appears on the display. Turn the volume
knob to increase or to decrease the bass.
The display will show the bass level. When
finished making the selection, press the
SOUND button to select the bass level.
Press the SOUND button until "TRE"
appears on the display. Turn the volume
knob to increase or to decrease the treble.
The display will show the treble level.
When finished making the selection, press
the SOUND button to select the treble
level. If a station is weak or noisy,
decrease the treble.
Adjusting the Speakers (Balance/Fade)
To adjust the balance between the right
and the left speakers, press the SOUND
button until "BAL" appears on the display.
Turn the volume knob to shift the balance
between the right and left speakers. The
display will show the balance level. When
finished making the selection, press the
SOUND button to select the balance level.
To adjust the fade between the front and
the rear speakers, press the SOUND but-
ton until "FAD" appears on the display.
3-71
Downloaded from
www.Manualslib.com
Turn the volume knob to shift the balance
between the front and the rear speakers.
The display will show the fade level. When
finished making the selection, press the
SOUND button to select the fade level.
Setting the Equalization
The scroll order for the customized equal-
ization settings is EQ OFF, CLASSIC,
DANCE, ROCK, JAZZ, POP, VOICE,
TECHNO, EQ OFF.
Press the SOUND button until "EQ OFF"
appears on the display to select custom-
ized equalization settings designed for
classic, dance, rock, jazz, pop, voice and
techno music. Turn the volume knob until
the desired equalization setting appears
on the display. When finished making the
selection, press the SOUND button to
select the equalization setting.
To cancel an equalization setting, press
the SOUND button until "EQ OFF" appears
on the display, turn the volume knob until
"OFF" appears on the display, then press
the SOUND button again.
manuals search engine
PLAYING A TAPE
Insert a tape into the tape insert hole (7).
You can see the message "LOAD" and
"PLAY".
1 DIR button (5):
Press this button to active the DOLBY
function. The purpose of the DOLBY func-
tion is to delete tape noise.
2 RPT (Repeat) button (5):
Press this button to repeat the current
track. "RPT" will appear on the display.
Press this button again to turn off repeat
play.
TUNE button (3):
Press the down arrows to go to rewind to
the first track on the current side of the
tape. "REW" will appear on the display.
When the tape is fully rewound, it is played
back from the beginning of the same side.
To stop the rewind movement, press the
TAPE button (8) or the down arrows button
or the repeat button (5). The repeat button
(5) is effective to only the case when the
repeat function is not active.
Press the up arrows to advance to the first
track on the opposite side of the tape. "FF"
will appear on the display. When the tape
reaches the end, it is automatically
reversed and played back from the begin-
ning of the opposite side. To stop the fast
forward movement, press the TAPE button
(8) or the up arrows button or the repeat
button (5). The repeat button (5) is effec-
Hide quick links:
Advertisement
Table of Contents
