Setting The Equalization - Suzuki reno 2006 Owner's Manual

INSTRUMENT PANEL
Turn the volume knob to shift the balance
between the front and the rear speakers.
The display will show the fade level. When
finished making the selection, press the
SOUND button to set the fade level.

Setting the Equalization

The scroll order for the customized equal-
ization settings is EQ OFF, CLASSIC,
DANCE, ROCK, JAZZ, POP, VOICE,
TECHNO, EQ OFF.
Press the SOUND button until "EQ OFF"
appears on the display to select custom-
ized equalization settings designed for
classic, dance, rock, jazz, pop, voice and
techno music. Turn the volume knob until
the desired equalization setting appears
on the display.
When finished making the selection, press
the SOUND button to set the equalization
setting.
To cancel an equalization setting, press
the SOUND button until "EQ OFF" appears
on the display, turn the volume knob until
"OFF" appears on the display, then press
the SOUND button again.
3-57
Downloaded from www.Manualslib.com
PLAYING A CD(s)
LOAD button (9):
Press this button to load CDs into the CD
player. This CD player will hold up to six
CDs.
1) Press and release the LOAD button. A
message to select a slot number from
1–6 will appear on display.
2) Press the desired slot number. Wait for
the message to insert the disc.
3) Load a CD. Insert the CD partway into
the slot, label side up. The player will
pull the CD in.
To insert multiple CDs, do the following:
1) Press and hold the LOAD button for two
seconds. You will hear a beep and a
message to load multiple discs will be
displayed.
2) Follow the displayed instruction on
when to insert the discs. The CD player
takes up to six CDs.
3) Press the LOAD button again to cancel
loading more CDs.
As each CD is inserted, "CDP" will appear
on the display and as each CD is loading,
"Filecheck" will appear on the display.
Once playback begins, the track and track
number will appear on the display.
If the ignition or radio is turned off with a
CD in the player, it will stay in the player.
When a CD is in the player and the ignition
is turned on, the radio must be turned on
before the current CD will start playback.
manuals search engine
When the ignition and radio are turned on,
the CD will start playing where it stopped, if
it was the last selected audio source.
The CD player can play the smaller 3 inch
(8 cm) single CDs with an adapter ring.
Full-size CDs and the smaller CDs are
loaded in the same manner.
If playing a CD-R, the sound quality may
be reduced due to CD-R quality, the
method of recording, the quality of the
music that has been recorded, and the
way the CD-R has been handled. There
may be an increase in skipping, difficulty in
finding tracks, and/or difficulty in loading
and ejecting. If these problems occur,
check the bottom surface of the CD. If the
surface of the CD is damaged, such as
cracked, broken, or scratched, the CD will
not play properly. If the surface of the CD
is soiled, see "Cautions on Handling" for
more information.
If there is no apparent damage, try a
known good CD.
Do not add any label to a CD, it could get
caught in the CD player. If a CD is
recorded on a personal computer and a
description label is needed, try labeling the
top of the recorded CD with a marking pen
instead.