Table of Contents
Advertisement
Auto Reverse
When the tape reaches at the end of one
side, it will automatically reverse and play
back the other side of tape.
Fast Forward / Rewind Function
Fast Forward:
To fast forward wind a tape, press the fast
forward button for more than 1.5 seconds.
The "FF" indicator appears on the VFD.
When the tape reaches the end, it is auto-
matically reversed and played back from
the beginning of the opposite side.
To stop the fast forward movement, press
the cassette on/program button.
Rewind:
To rewind a tape, press the rewind button
for more than 1.5 seconds.
The "RE" indicator appears on the VFD.
When the tape is fully rewound, it is played
back from the beginning of the same side.
To stop the rewind movement, press the
cassette on/program button.
AMS (Auto Music Search) Function
The AMS function searches for the begin-
ning of a music track by identifying the
blank interval between tracks.
If there is a blank interval within a music
track or there is no interval between music
tracks, the system may not search cor-
rectly.
Downloaded from
www.Manualslib.com
For the AMS function to work properly, an
interval of at least 4 seconds between
each music track is required.
To listen to the next track, press the button
for less than 1.5 seconds. The "A-FF" indi-
cator appears on the VFD. The tape
moves forward and it is played back from
the beginning of the next track.
If you press the rewind button for less than
1.5 seconds, the "A-RE" indicator appears
on the VFD and the tape rewinds. Then it
is played back from the beginning of the
current track.
To listen to the previous track, press the
rewind button again when the tape stops at
the beginning of the current track.
The AMS function is automatically can-
celed after finishing its function.
To cancel in the middle of AMS operation,
press the fast forward or rewind button
again.
Metal Tape Auto-Sensing
This unit has metal tape auto-sensing
function. If a metal tape is inserted, the
"MTL" indicator appears on the VFD.
Dolby B Noise Reduction Function
Press the dolby B noise reduction button
when playing back a tape which has been
recorded using a dolby noise reduction
system.
The dolby symbol will be illuminated on the
VFD.
manuals search engine
INSTRUMENT PANEL
This system improves the signal to noise
ratio of the tape section, resulting in
reduced audible "hiss" during playback.
Repeat Function
Press the "RPT" button to repeatedly listen
to the current track.
The repeat indicator "RPT" will be illumi-
nated in the VFD, and the current track will
be played repeatedly until this function is
canceled.
To cancel this function, press this button
again.
The repeat function requires an interval of
about 4 seconds between each music
track to work properly.
3-36
Hide quick links:
Advertisement
Table of Contents
