Operational Check For The Remote Control; Accessing The Basic User Interface (Bui); Table 9 - Remote Control Test - Arris VMS1100 Installation And Operation Manual

Installation

Operational Check for the Remote Control

The operational check tests communication with the remote control.
FEATURE
Power ON
Channel Selection
Volume Control
If the VMS1100 does not operate properly, see

Accessing the Basic User Interface (BUI)

The BUI contains onscreen display (OSD) diagnostics, front panel diagnostics, and user settings. The BUI
allows you to retrieve diagnostics without having to power OFF the application.
Note: It is recommended that you use the BUI menu to access the OSD diagnostics. Do the following to
open the OSD diagnostics:
1. Method 1 - Press and hold the D key on the IR remote control for five seconds and then release the key
to display the BUI Main Menu (see Figure 30).
a. Select Diagnostics to navigate to the onscreen diagnostics.
b. Select User Settings to navigate to the high-definition video User Settings menu.
2. Method 2 – Power ON the VMS1100 and then immediately press the Select key (or OK key) on the IR
remote control twice.
VMS1100 Hybrid QAM/IP Video Media Server • Installation and Operation Manual
365-095-25654 x.1
Table 9 – Remote Control Test
TESTING PROCEDURE
Press Power on the remote control to turn ON the VMS1100.
Tune to the output channel (3 or 4), if using the RF output.
Scan through the channels using the Channel + or - keys.
Tune to several channels by entering the channel number
using the numeric keys.
Press Volume + or - on the remote control to increase the
volume to its upper limit, lowest level, and to a comfortable
level.
Press mute to turn the sound off. Press mute again to restore
the sound.
Troubleshooting
This document is uncontrolled pending incorporation in an ARRIS CMS
for more information.
35