Connecting The Home Router; Connecting The Home Router - Embedded Moca Ont; Installation Overview - Arris VMS1100 Installation And Operation Manual

Installation

Connecting the Home Router

To connect the home router:
1. Connect the Ethernet cable you routed from the ONT to the WAN Ethernet port on the home router.
2. Make sure the router is powered ON.
3. Enable Dynamic Host Configuration Protocol (DHCP) on the router. Follow the instructions provided with
the router.
Connecting the Home Router – Embedded MoCA ONT
To connect the home router:
1. Connect the coaxial cable you routed from the ONT to the coax/MoCA port on the home router.
2. Make sure the router is powered ON.
3. Enable Dynamic Host Configuration Protocol (DHCP) on the router. Follow the instructions provided with
the router.

Installation Overview

1. Determine if you are connecting to one of the following:
a. High-Definition TV or monitor - Use the HDMI or component video (YPbPr) output. No other video
connection supports HDTV.
If the TV has no HDMI input but does have a DVI input, connect a DVI-to-HDMI adapter or cable to the
HDMI out connector on the VMS set-top and the DVI-HDTV connector on your TV.
b. Standard-Definition TV - Connect the composite video connector using a composite (RCA phono)
cable.
2. Determine if you are connecting the audio to a home theater receiver or directly to the TV:
a. For an HDMI video connection, no additional audio connections to the TV are required.
b. For a DVI video connection, additional audio connections to the TV are required.
c. If the receiver or TV has a digital audio (S/PDIF) input, use the Optical Audio (S/PDIF) or Digital Audio
(Coaxial) outputs. Otherwise, use the baseband left and right audio outputs.
3. Locate the cabling diagram(s) that best match your planned configuration.
4. Connect the audio and video cables as shown in the diagram you are using.
5. Determine if you are connecting to a data device. For installation details, refer to the instructions included
with the data device.
6. Connect the FiOS TV In terminal to the coaxial cable wall outlet.
7. Perform the operational check for the remote control.
8. Optimize the high-definition settings (see
VMS1100 Hybrid QAM/IP Video Media Server • Installation and Operation Manual
365-095-25654 x.1
Optimizing the High Definition
This document is uncontrolled pending incorporation in an ARRIS CMS
Settings).
19