Arris VMS1100 Installation And Operation Manual page 4

Safety and Compliance
During Installation
• Do not place the VMS in an enclosed area where the cooling vents are blocked or impede the flow of air
through the ventilation openings.
• Install the VMS so that its position does not interfere with its proper ventilation. For example, do not place the
VMS on a bed, sofa, rug, or similar surface that could block the ventilation openings.
• Install the VMS away from heat sources such as radiators, heat registers and stoves. Installation of the VMS
near consumer electronics devices, such as stereo receiver/amplifiers and televisions, is permitted as long as
the air surrounding the VMS does not exceed 40º C (104º F).
• Place the VMS on a flat surface not prone to vibration or impact.
• Do not install the VMS in an area where condensation occurs.
• To prevent the temporary loss of guide data and cause a temporarily non-responding VMS, do not plug the AC
power cord into a switched power outlet.
• To avoid shock and vibration damage to the internal hard drive, do not move the VMS while it is plugged in.
• To allow the hard drive to spin down and park its heads, wait at least 10 seconds after disconnecting power
before moving the VMS.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by ARRIS for compliance could void
the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
VMS1100 Hybrid QAM/IP Video Media Server • Installation and Operation Manual
365-095-25654 x.1 This document is uncontrolled pending incorporation in an ARRIS CMS
ii