ETC Desire series User Manual page 18

Connections
All connections and user controls are located on the back of the fixture, depending on the
model. This section does not apply to the D60X fixture as there is no rear display.
Power In
Power Thru
Figure-1.6 Power and DMX connections on the back of the D40 or D60 Fixture.
Power In
Indicator lights
Figure-1.7 Power and DMX/RDM connections on the back of the D22 Portable Fixture.
Figure-1.8 Power and DMX Connections on the back of the D60X fixture
Depending on the fixture model, connect AC input power and DMX data cables to the
appropriate ports. Connect the incoming DMX data cable to the DMX Input connector. If you
are daisy-chaining the data to other fixtures or DMX-controlled devices, connect the next
DMX cable to the DMX Thru connector. Up to 32 fixtures can be connected together into a
data daisy-chain.
For information about the user interface, refer to
Installation and User Interface
User Interface Overview
DMX In
DMX Thru
Indicator lights
DMX/RDM
In
DMX/RDM
Thru
page 46.
on
29