Setting Pressure Parameters During Initial Start-Up - Bresser 4 cast PC Instruction Manual

2.5 SETTING PRESSURE PARAMETERS DURING INITIAL START-UP

This part of the display indicates the current pressure, sea level pressure, and moon phase.
A number of historical statistics can also be viewed, such as the sea-level pressure values for
the last 24 hours, moon phase for the previous and next 39 days, as well as a pressure/
temperature/ humidity history bar-chart.
Pressure values may be displayed inHg, hPa/mBar or mmHg, and altitude values may be
displayed in meters or feet.
ACCESSING PRESSURE AND WEATHER FORECAST MODE
From the main console unit: [
SETTING PRESSURE PARAMETERS DURING INITIAL START-UP
During the initial start-up of the Main Unit, the pressure settings should be configured in
following steps.
1. Choose Pressure Units:
The unit icon "inHg" or "mmHg" or "hPa/mBar" should be flashing. [
pressure unit as inHg, hPa/mBar or mmHg
Press [ SET ] to confirm your selection.
2. Choose Altitude Units:
Press [ ] or [ ] to select altitude unit as feet or meters.
Press [ SET ] to confirm your selection.
3. Set Altitude:
[ ] or [ ]to adjust value. Press and hold either button for fast advance.
Press [ SET ] to confirm your selection.
4. Upon completion the display will be returned to Pressure and Weather Forecast Mode.
Note: After initial start-up the altitude cannot be adjusted immediately
VIEWING PRESSURE AND ALTITUDE DATA
In Pressure Mode, each press of [ SET ] rotates display between:
• Sea level pressure
• Local pressure
• Local altitude
SETTING THE SEA LEVEL PRESSURE
1. In Pressure Mode, press [ SET ] until the sea level pressure is displayed.
2. Press and hold [ SET ]. The Sea Level Pressure display should be flashing.
3. Set Sea Level Pressure:
[ ] or [ ] to adjust value. Press and hold either button for fast advance.
Press [ SET ] to confirm your selection.
4. Upon completion the display will be returned to Pressure Mode.
] or [ ]until the weather forecast icon
71
GB/IE
starts flashing.
] or [ ] to select