Volvo Penta AQUAMATIC 280 Workshop Manual page 92

2
13. Lift out the pinion (1) and the needle bearing wash-
er (2).
NOTE! The needle bearing is a full needle type of
bearing with loose needles (3). Remove all 27 nee-
dles.
14. Carefully lift off the lower gear housing from the
vertical drive shaft.
NOTE! Take care of the shims (1).
1
3
1
884381
884143
15. Press (knock) off the outer ring of the needle bear-
ing. Use special tools 884381 and 884143. Insert the
tool from underneath and the shaft from above.
16. Press off the ball and roller bearings from the ver-
tical shaft (against the frame of the press).
NOTE! There are spacer pads between the bearings.
Repair instructions
89