Volvo Penta AQUAMATIC 280 Workshop Manual page 16

884975
885009
885148
885197
1)
884975-4 Installation tool
884976-2 1 ) Protection sleeve
884978-8 Trim cylinder removal tool, intermediate
884982-0 Disassembly tool for outer bearing race.
Intermediate housing, extension.
885008-3 Allen wrench, upper, intermediate & lower
gears
885009-1 Cap wrench
885043-0 Torx 50 bit – Input gear
885127-1 Installation/dismantling tool – propellers
885143-8 Yoke, holding the sterndrive while install-
ing the clamps for the bellows. Models
290, SP, DP
885146-1 2) Suspension tool
1)
Included in kit no. 884977
2) Earlier part no. 884862
884976
885043
885149
885207
884978
885127 885143
885153
885208 885209
885148-7 Pin remover, intermediate
885149-5 Drilling jigg, duoprop, lower
885152-9 Kit containing tools 884387 and 885153
885153-7 Spacer ring, mounting plate, upper
885192-5 Suspension fixture
885197-4 Tool, duoprop, threaded screw, lower
3)
885207-1 Hook spanner, power steering cylinder
3)
885208-9 Hook spanner, power steering cylinder
885209-7 3) Sleeve, power steering cylinder
885226-1 Drift, bearing remover, lower
885227-9 Spacer ring
3) These special tools have been designed for the overhaul of the
power steering cylinder. The overhaul procedure is described in
the Installation instruction , publ. no. 7734865-4, included in
the overhaul kit part no. 872697-8. The tool can be ordered on the
usual parts form.
Special tools
884982 885008
885146
885192
885226 885227
13