Volvo Penta AQUAMATIC 280 Workshop Manual page 90

5. Remove the 6 nuts holding the washer (1) and
knock the propeller shaft out of the bearing housing.
Use a copper mallet or its equivalent in order not to
damage the threads.
2
6. Fold down the locking washer (1) remove the round
nut (2).
1
7. Press off the gear wheel and the bearing from the
propeller shaft simultaneously. Use special tool
884168.
1
8. Remove the locking ring (1) and the oil deflector (2)
from the gear wheel.
NOTE! In order not to damage the oil deflector dur-
ing the dismantling, apply the bending tool close to
the 2 carrier pins (3). (This is valid for sterndrives of
earlier manufacture). On sterndrives of later manu-
facture the carrier pins have been replaced by a load
pin.
884168
3
1
Repair instructions
3
2
87