Volvo Penta AQUAMATIC 280 Workshop Manual page 70

Assembly
Oil all moving parts prior to assembly.
9. Lubricate the sealing ring abundantly and install it
with the steel edge (small clearance) facing inwards
the gear housing.
10. Install the excentric piston (1). Install the pin (2)
and lock it with the load pin (3). Make sure that the
load pin centers in the excentric piston.
11. Install the spring (1), the sliding shoe (2) and the
O-ring (3) and coat the contact surfaces with sealing
compound, Volvo Penta part no. 1161099-5, or
Permatex ® no. 3.
12. Install the shift mechanism in the gear housing in
a way that the screw (1) is displaced towards star-
board.
NOTE! Make sure that the sliding shoe (2) is turned to
a position corresponding the one in the picture. The
shift mechanism will not function if the sliding shoe is
turned the opposite way.
Repair instructions
67