Volvo Penta AQUAMATIC 280 Workshop Manual page 47

Repair instructions
10. Install the shims and the 2 new O-rings on the
double bearing box.
11. Install the clamp ring and the double bearing box
on the universal joint.
NOTE! The guide pin (1) must fit the groove in the
clamp ring. Install the washer (2) and the screw (3).
At final assembly always use a new screw! Coat the
screw with Volvo Penta part no. 1161053-2, locking
fluid and tighten with a torque of 75 Nm (55 lb.ft.).
44
12. Apply Volvo Penta part no. 1161099-5, Permatex
no. 3 on the surfaces between the clamp ring and gear
housing.
Install the double bearing box along with the universal
joint in the gear housing. The guide pin in the double
bearing box should be turned downwards. Lock the
screws with thread locking compound, Volvo Penta
part no. 1161053-2 and tighten them with a torque of
35 Nm (25.8 lb.ft.).
If necessary, recondition the universal joint. See
chapter Reconditioning the universal joint , pages
62–63.
13. Install shims under the cover to obtain a clearance
of max 0.1 mm (0.004") between the cover and the
gear housing. Install the cover and push it into its po-
sition and measure the clearance with a feeler gauge
all around.
®