Volvo Penta AQUAMATIC 280 Workshop Manual page 136

5. Remove the cover over the shift mechanism.
Hang a hose clamp on the sterndrive and install the
yoke on the sterndrive. Then lift up the sterndrive
and hang it in the tool 885146.
6. Push the shift cable as far into the sterndrive as
to allow the locking to lock the cable in its groove in
the cable cover. Tighten the locking plate with the 2
stainless steel screws. Key width 11 mm.
885146
7. Install the plastic bushings (1) in the holes (2) of
the suspension yoke.
8. Push the sterndrive forwards against the engine
primary shaft and turn the universal joint simultane-
ously to better allow the primary shaft splines to en-
ter the universal joint. A small guide in the joint facili-
tates the finding of the correct position.
NOTE! Install the bellow with the "UP" marking up.
Repair instructions
UP
133