Volvo Penta AQUAMATIC 280 Workshop Manual page 87

Repair instructions
9. Place the wear washer (1) on the intermediate
housing and push the steering spindle (2) in far
enough to hold the wear washer.
10. Push the steering spindle (1) through the interme-
diate housing exhaust port (2) stopping short of the
upper hook up fork bushing.
84
11. Insert the plastic wear washer (1) between the in-
termediate housing and the hook up fork. Push the
steering spindle in until the collar bottoms.
12. Install the O-ring and the hose connection on the
yoke. Use a small amount of Volvo Penta part no.
828250-1 water resistant grease to hold the O-ring in
place while installing the hose connection.