Volvo Penta AQUAMATIC 280 Workshop Manual page 137

Repair instructions
9. Push the sterndrive forwards. Lift up the trim cyl-
inders simultaneously and continue to push the
sterndrive forwards.
10. Push the sterndrive suspension yoke into the
transom shield and align the yoke with the suspen-
sion dowels in the shield. Knock the dowels into posi-
tion and use a rubber mallet.
NOTE! Don't use a hammer in order to avoid damag-
ing the dowels thus not making the future dismantling
more difficult.
134
11. Use a screwdriver to turn the dowels so that the
locking grooves coincide with the locking screw holes
in the ears of the transom shield. Tighten the locking
screws. Prior to the tightening of the screws, grease
them with low temperature grease, Volvo Penta part
no. 1141644-3.
NOTE! Don't forget the washer under the screw
heads.
Tighten torque: 24 Nm (17 lb.ft).
Remove the installation tool.
12. Push the rubber bellows on to the neck of the up-
per gear housing. Check to make sure that the bel-
lows is installed correctly and push on the hose
clamp and tighten it with the tightening screw located
on the underside of the bellows. Use special tool
884573.
884573