Volvo Penta AQUAMATIC 280 Workshop Manual page 73

Repair instructions
22. Install the eccentric piston (1) in the housing. Do
not damage the seal! Push in the locating pin (2).
Align the hole with the housing. Lock it in place with a
new spring pin (3).
23. Install a new O-ring (3) and insert the spring (2)
and the sliding shoe (1). Coat the contact surface with
Volvo Penta part no. 1141570-0 sealant.
70
1 2 3
1
2
3
24. Install the shift mechanism in the gear housing in
a way that the screw (1) is displaced towards star-
board.
NOTE! Make sure that the sliding shoe (2) is turned
to a position as indicated in the picture. The shift
mechanism will not function if the sliding shoe is
turned in the opposite direction.
25. Set the shift mechanism in a position between
forward and neutral or between reverse and neutral.
(The pin (1) shall rest on one of the 'cams'). Install the
shift mechanism in the sterndrive.