Volvo Penta AQUAMATIC 280 Workshop Manual page 126

1
5. Install the O-ring (1) on the upper gear.
3
885008
6. Install the upper gear housing on the intermediate
housing. Use new Allen bolts (1, 2 pcs), washers (2,
2 pcs) and nyloc nuts (3). Many drives do not have
washers under the bolt heads. When overhauling
however, washers shall always be fitted. This applies
to all drives. Apply some grease to the Allen bolt and
stud threads, and to the contact faces of the nuts and
washers. Tighten the screws and nuts in diagonal
sequence and evenly all around and with a torque of
38 Nm (28 lb.ft). Use tool 885008 and 885009.
7. Install the shift linkage rod, washer and cotter pin.
WARNING! Always use a new cotter pin. Never
reuse a cotter pin that has been removed.
2
1
885009
Repair instructions
123