Table of Contents
Advertisement
1. Briefinstruction
This model is designed with needle bar to take up thread and spreader
mechanism to catch thread loop producing Stitch 103 and straight blind stitch seam by
one arched needle and one spreader. Also it is equipped with regulation mechanism to
adjust presser foot pressure, thread tension, stitch length, feed lifting, presser foot left
and feed ratio for blind stitching light to medium heavy weight fabrics or sewing
operations, such as trousers cuff, lap, fore pant of suit, etc.
It is requested to read this instruction manual carefully before operating the machine,
for best machine performance.
2. Main Specification
(!)Max. Sewing speed
(2)Max. Stitch length
(3)Feed ratio
( 4)Presser foot lift
(5)Needle
(6)Thread
(7)Motor power
(8)Measurements
(9)Gross weight
2500 r.p.m.
3mm-8mm
1:1
2:1
7mm
GLX 1 NM75-100 (LWX 6T 3#-4#)
14.5-7.5 tex cotton
14.8-7.4 tex terylene cotton
270W
510X360 X 245
24.5kgs
3. Installation and Preparation
A. Installation
1.
Take Machine Head out
When taking machine head out of the packing, be careful not to damage
the exposed parts such as thread tension, thread guide etc.
Don't dispose of any packing material before checking up with the packing
list in order to avoid any parts missing.
n.
Install the Stand
a. First assemble back brace and treadle brace with left and right legs,
then set treadle holders to treadle brace.
b. Install motor onto table.
c. Set table onto stand with washers and wood screws.
d. Connect motor and treadle lever by draw bars. After adjusting treadle
position, tighten the nuts for draw bar joint and treadle.
111.
Install the machine
Advertisement
Table of Contents
