3-3 Connection of the foot switch
Connect the foot switch
3-4 Installation of the oil pan
(1) Fix the oil pan
3-5 Installation of the sewing machine head
Caution
★ For the safety,please make sure to
carry the sewing machine head by more
than two people.
(1) Make sure to hold the machine table
with the caster stopper.
(2) Fit the rubber cushion pads
○
4 on the tabletop . The
each hole
rubber cushion pads are enclosed in the
accessory box.
(3) Put the sewing machine head on the
table top and set the each leg②to the
each rubber cushion pad
(4) Attach two hinges
machine bed .
(5) At this time, take notice that the E-shaped snap ring on the front side hinge must be come to the backside,
and E-shaped snap ring on the backside hinge must be come to the front.
(6) These parts are all enclosed in the accessory box.
(7) Fit the screw holes
○
10 through these holes and fasten the bolt
○
washers
12 and the nuts
(8) Fasten firmly hexagonal socket head set screws
○
hinges
6 perfectly.
(9) Insert the headrest
○
6 to the control box
○
1 at its four corners on the table top with four
○
3 into the
○
3 .
○
6 temporarily,make the setting screw
○
○
9 of the hinges
6 to the bolt setting holes
○
13 .
○
○
14 into the hole
15 on the tabletop.
○
7 .The foot switch is enclosed in the accessory box.
○
7 fastening on the left side surface of the
○
○
○
10 to fix the hinges
6 with the flat washers
○
7 ,which set the hinges
4
8 on the table top then,pass the bolt
○
11 ,the spring
○
6 temporarily then,fix the