Beko METPOINT OCV Installation And Operation Manual page 30

Installation
Mounting of the stationary seal ring and of the screw-connection body (steps 7 – 8)
Removal of the probe closure (step 9)
Connection of the probe with the sensor unit and mounting of the stationary seal ring (step 10)
30
7. Please place the stationary seal ring (6) on the
mounting point on
measuring section.
8. Now screw the screw-connection body (5),
unfastened in step 6, into the thread at the
measuring section. Make sure not to damage
the stationary seal ring when doing so.
9. Please remove the closing plug (V) with the
second stationary seal ring with a suitable
hollow hexagon wrench.
10. Connect the probe (3) with the sensor unit (1).
Please make sure not to damage the second
stationary seal ring (6) when doing so.
the already-installed
METPOINT ® OCV