Details - Sharp AR-M550N Service Manual

8. Details

Main Sub
Title MC trouble
code code
C1 00 Phenomenon Display
Details
Section
Operation
mode
Note
Case 1 Trouble
position/
Cause
Remedy
Note
Case 2 Trouble
position/
Cause
Remedy
Note
Case 3 Trouble
position/
Cause
Remedy
Note
Main Sub Another communication error
Title
code code occurs.
CE 00 Phenomenon Display
Details
Section
Operation
mode
Note
Case 1 Trouble
position/
Cause
Remedy
Note
Lamp
Message
MC trouble
Three successive MHV-T
signals are detected
during operation of MHV.
Main charger output
abnormality (Output
open)
A trouble signal is
outputted from the high
voltage transformer.
Engine
The main charger is not
installed properly.
The main charger is not
assembled properly.
Use SIM 8-2 to check the
main charger output.
Main charger
disconnection check
The high voltage
transformer connector is
disconnected.
The high voltage harness
is disconnected or
broken.
Connection check
High voltage unit trouble
Replace the high voltage
unit.
Lamp
Message
Communication error
Improper connection of
the network cable
Check the connection of
the network cable.
AR-M550/M620/M700 SELF DIAG MESSAGE AND TROUBLESHOOTING 9 - 7
Main Sub The network card is not installed or
Title
code code broken.
CE 01 Phenomenon Display
Details
Section
Operation
mode
Note
Case 1 Trouble
position/
Cause
Remedy
Note
Case 2 Trouble
position/
Cause
Remedy
Note
Main Sub The specified mail server or the
Title
code code FTP server is not found.
CE 02 Phenomenon Display
Details
Section
Operation
mode
Note
Case 1 Trouble
position/
Cause
Remedy
Note
Case 2 Trouble
position/
Cause
Remedy
Note
Lamp
Message
Network card connection
trouble
The network card is not
installed on the controller.
Check that the network
card is installed on the
controller.
Network card control
PWB trouble
1. Output the NIC Config.
Page to check the NIC
version.
2. Replace the NIC.
Lamp
Message
The specified mail server
or the FTP server is not
found.
Improper connection of
the network cable
Check that the network
cable is properly
connected.
Network setup trouble
1. Check that the
connected network
supports TCP/IP
protocol.
2. As Primary/Secondary
E-mail Server Address
or Destination from
Web Page
3. When the above
address is described
with the Hostname,
check that the DNS
server is properly set
or not.