Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual page 31

Start Up and Functional Tes...
CAUTION
MOTOR START!
Ensure that the motor, system, and any attached
equipment is ready for start. It is the responsibility of the
user to ensure safe operation under any operational
condition. Failure to ensure that the motor, system, and
any attached equipment is ready for start could result in
personal injury or equipment damage.
3 3
1. Press [Auto On].
2. Ensure that external control functions are
properly wired to the frequency converter and all
programming completed.
3. Apply an external run command.
4. Adjust the speed reference throughout the speed
range.
5. Remove the external run command.
6. Note any problems.
If warnings or alarms occur, see 8 Warnings and Alarms.
28
®
VLT AQUA Drive
Operating Instructions
®
MG.20.M8.02 - VLT is a registered Danfoss trademark