Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual page 24

Installation
1
Illustration 2.23 Installation to Achieve a Stopping Category 0 (EN 60204-1) with Safety Cat. 3 (EN 954-1) / PL "d" (ISO 13849-1).
1 Safety device Cat. 3 (circuit interrupt device, possibly
with release input)
2 Door contact
3 Contactor (Coast)
4 Frequency converter
5 Mains
6 Control board
Table 2.5
Safe Stop Commissioning Test
After installation and before first operation, perform a commissioning test of the installation making use of safe stop.
Moreover, perform the test after each modification of the installation.
®
VLT AQUA Drive
Operating Instructions
3
2
11
10
7 Inverter
8 Motor
9 5V DC
10 Safe channel
11 Short-circuit protected cable (if not inside installation cabinet)
®
MG.20.M8.02 - VLT is a registered Danfoss trademark
4
12
37
9
5
2
6
7
8
M
21
2