Siemens SIMATIC VS120 Operating Instructions Manual page 64

Commissioning
8.4 Establish an Ethernet connection between the processing unit and PG / PC
Step 1: Checking the IP setting of the PC / PG
1. Click Start > Settings > Network and Dial-up Connections
2. In the "Network and Dial-up Connections" dialog, select your active local area connection
3. Select "Properties" in the context menu and select the "Internet Protocol (TCP/IP)" entry.
4. Click the "Properties" button
5. Note down the displayed IP address and subnet mask of your PC / PG.
Step 2: Manual configuration of the VS120 processing unit
Notice
• The IP address of the VS120 processing unit must be in the same subnet as the IP
• The default gateway is not necessary for a direct connection between the VS120
1. After turning on the VS120 processing unit and after the self-test is completed, go to the
2. Confirm the selected "Ports" menu command with "OK".
3. Change to the "Ethernet" menu and confirm with "OK"
4. Confirm the selected "IP Mode" menu command with "OK".
5. Select "Manual" and confirm with "OK"
6. Change to the "IP Address" menu and confirm with "OK"
7. Now enter the IP address of the VS120 processing unit with the arrow keys and confirm
8. Change to the "IP Mask" menu and confirm with "OK"
9. Enter the subnet mask with the arrow keys and confirm with "OK"
Step 3: Establish the Ethernet connection
1. Establish an Ethernet connection between the VS120 processing unit and PC / PG. Use
Next step
Perform the activities described in the section
8-8
to the network
address of the PC.
processing unit and a PC / PG
"Connect" menu and confirm with "OK".
with "OK".
a network cable of the type "Ethernet RJ-45 (crossover)"
Check the connection
.
Vision Sensor SIMATIC VS120
Operating Instructions, Edition 02/2006, A5E00757507-01