Inserting The Accessories - AEG PROCOMBI PLUS BS9354801 User Manual

26 www.aeg.com
The display shows the core temperature
sensor symbol.
4. Use the shuttle in less than 5 seconds
to set the core temperature.
5. Set the heating function and, if
necessary, the oven temperature.
The appliance calculates an approximate
end time. The end time is different for
the different quantities of the food, the
set oven temperatures (minimum 120 °C)
and the operating modes. The appliance
calculates the end time in approximately
30 minutes.
6. To change the core temperature,
press
When the meat is at the set core
temperature, an acoustic signal sounds.
The appliance deactivates automatically.
7. Touch any symbol to stop the signal.
8. Remove the core temperature sensor
plug from the socket and remove the
meat from the oven.
WARNING!
The core temperature sensor
is hot. There is a risk of
burns. Be careful when you
remove the tip and the plug
of the core temperature
sensor.

9.2 Inserting the accessories

Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
.
Deep pan:
Push the deep pan between the guide
bars of the shelf support.
Wire shelf and the deep pan together:
Push the deep pan between the guide
bars of the shelf support and the wire
shelf on the guide bars above.
All accessories have small
indentations at the top of
the right and left side to
increase safety. The
indentations are also anti-tip
devices.
The high rim around the
shelf is a device which
prevents cookware from
slipping.