Tenda teg2124t User Manual page 91

Wireless N150 Long Range AP/Router
A: 1) Check if there are other DHCP servers present in your LAN. If there are other
DHCP servers except your router, disable them immediately.
2) The default IP address of the device is 192.168.2.1; make sure this address is not
used by another PC or device. In case that two computers or devices share the
same IP addresses, change either to a different address.
4. Q:My computer can neither log in to the device nor access Internet, and
there is a yellow triangle with an exclamation mark shown in the network
adapter icon on the right bottom corner of my computer desktop; how am I
supposed to deal with it?
A: This problem occurs because your network card has not been assigned with an
IP address. If your computer is set to obtain an IP address automatically, please
ensure that the router's DHCP function is enabled. DHCP can automatically assign
an IP address to your computer. If there is no DHCP server available on your
network, please set a static IP address and fill in gateway and DNS, otherwise you
cannot access Internet.
5. Q: How do I share resources on my computer with users on Internet
through the device?
A: To let Internet users access internal servers on your LAN such as e-mail server,
Web, FTP, via the device, use the "Virtual Server" feature. To do so, follow steps
below:
Step 1: Create your internal server, make sure the LAN users can access these
servers and you need to know related service ports, for example, port for Web
server is 80; FTP is 21; SMTP is 25 and POP3 is 110.
Step 2: Click "Virtual Server" and select "Port Range Forwarding" (also known as
Port Forwarding on some devices) on device's web interface.
Step 3: Input the Start Port/External Port, say, 80.
Step 4: Input the End Port/Internal Port, say, 80.
Input the internal server's IP address. For example, assuming that your Web
server's IP address is 192.168. 2.10, then simply input it.
91