Tenda teg2124t User Manual page 12

Wireless N150 Long Range AP/Router
2. Connect PC to injector's LAN port using an Ethernet cable or wirelessly to the
device via the SSID (The default SSID can be found on the label on the back of the
device and is not encrypted by default).
Note:
Device operates in AP mode by default. So you need to manually configure a static
IP address for your PC. AP's LAN IP address is preset to 192.168.2.1 by default.So
your PC's IP address should be 192.168.2.X (where X is any number between
2~254). For IP address configuration, see Appendix 1.
3. Use the Ping command to check the connectivity between your device and PC.
Click Start -> Run, enter cmd and press Enter or click OK to enter interface
below.
12