Tenda teg2124t User Manual page 30

network (VPN) links. By default it is disabled. However if ISP enables MPPE on
his PPPoE server, you must also enable it on the device. Consult your ISP, if
you don't know whether he has enabled the MPPE or not
Ø
Address mode: Select "Dynamic" if you don't get any IP info from your ISP,
otherwise select "Static". Consult your ISP if you are not clear
Ø IP Address: Enter the IP address provided by your ISP. Consult your local ISP
if you are not clear
Ø Subnet Mask: Enter the subnet mask provided by your ISP. Consult your ISP if
you are not clear
Ø
Gateway: Enter the gateway provided by your ISP. Consult your local ISP if
you
are not clear
Ø
Primary/Secondary DNS Server: Enter the Primary and Secondary DNS
Server Addresses. Consult your local ISP if you are not clear
Ø MTU: Maximum Transmission Unit. The factory default is 1460
L2TP
Select L2TP (Layer 2 Tunneling Protocol) if your ISP uses an L2TP connection. The
L2TP connects your router to a L2TP server. For example: A corporate branch and
headquarter can use this connection type to implement mutual and secure access
to each other's resources.
Wireless N150 Long Range AP/Router
30