Viewing The Team Configuration Using Curl - HP HPE VAN SDN Controller 2.7 Administrator's Manual

-ksSfL --request DELETE
--url https://member-ip:8443/sdn/v2.0/team
The deletion of the team can take up to 4 minutes to complete. Increase the read timeout
for the client request accordingly.
4. In order for the controller to be fully operational in standalone after a team is disbanded, you
must completely re-install the controller on each node.
Since team deletion is asynchronous, the response is always 202 unless there is a problem
configuring the local controller as standalone. Possible codes are:
202 Accepted
400 Bad request
401 Unauthorized
503 Service unavailable
If you get a returned error of 500, it might be that all regions have not been removed.
In case the team is not deleted in a quorum or if the team is partially deleted, an alert is posted.
Example of an alert for a team partially deleted
Team partially deleted: [Successes: 192.168.1.1, 192.168.1.2], [Failures: 192.168.1.3]
The alert does not include the error description, however, the error description is added to the
log files. Review the log files to get the cause of the partial team deletion.
To recover from this failure, Hewlett Packard Enterprise recommends that you delete the team
on each failed controller which will remove the configuration files and transition the controllers
to standalone mode.
Example of an alert for a team deletion that failed in a quorum
Team could not be deleted on a quorum
If a team cannot be deleted in a quorum, delete the failed controllers individually.

Viewing the team configuration using curl

To view your team configuration, do as follows:
1. Acquire an authentication token for the team leader. (See step 4 of "Prerequisites" (page
Team configuration using curl commands 187
182).)