Basic Configurations View - HP HPE VAN SDN Controller 2.7 Administrator's Manual

Basic Configurations view

Figure 11 Basic Configurations view
Components in the Basic configurations tab
com.hp.sdn.ctl.of.impl.ControllerManager
The ControllerManager component provides parameters used in the implementation of the
OpenFlow protocol. You can configure parameters such as hybrid.mode, keystore,
keystore.password, truststore, truststore.password.
com.hp.sdn.ctl.of.impl.TraceManager
The TraceManager controls OpenFlow trace duration.
◦
Use the record.duration key to specify how long a trace is to run after it starts.
com.hp.sdn.ctl.path.impl.PathDaemon
The PathDaemon component provides parameters used to perform L2 path calculations
based on IPv4 addresses for IPv4 packets or MAC addresses for ARP packets. You can
set the following flow timeout parameters:
◦
Use the idle.timeout key (default 60 seconds) to configure the idle timeout value
for each flow-mod. The idle timeout value specifies how long the flow-mod will remain
in the device if the flow-mod is not actively being used.
◦
Use the hard.timeout key (default 0, which implies infinite timeout) to configure the
hard timeout value for each flow-mod. The hard timeout value specifies how long the
flow-mod will remain in the datapath (regardless of usage).
40 Using the SDN controller UI