Table of Contents
Advertisement
X7 250ie
- Take out the oil seal using the appropriate tools.
- Fit the tie rod into the oil seal.
- Insert in sequence the two half-rings per Ø 35-
mm stems.
Specific tooling
020487Y Fork oil seal extractor
- Hold the tie rod manually so that it does not fall
into the fork led and/or that both half-rings lose are
not in their position.
- Fit the bell.
- Tighten the nut until it stops.
- Act on the tool until the oil seal is completely re-
moved.
Specific tooling
020487Y Fork oil seal extractor
- Remove the hydraulic rod with the corresponding
sealing gasket, the spring and the stop bushing.
COMPONENT CHECK
CAUTION
CLEAN ALL THE COMPONENTS THOROUGHLY.
Downloaded from
www.Manualslib.com
manuals search engine
Suspensions
SUSP - 9
Advertisement
Table of Contents
