X7 250ie
- In order to be able to anchor the specific tool
properly use a metal plate with an M8 threaded
hole and fix it to one of the two rear brake calliper
attachment points.
N.B.
SO AS NOT TO GET A DISTORTED READING,
CAUSE THE DRIVEN PULLEY SHAFT TO TURN
IN ORDER TO ROTATE THE DISC.
Specific tooling
020335Y Magnetic support for dial gauge
Characteristic
Max. deviation allowed:
0.1 mm
- If you detect incorrect values, replace the disc.
- If the fault continues, repeat the test.
- If the problem persists, replace the wheel.
Front brake disc
Removal
- Remove the front wheel.
- Undo the five clamping screws shown in the pho-
tograph
Downloaded from
www.Manualslib.com
manuals search engine
Braking system
BRAK SYS - 5