Removing The Starter Motor - PIAGGIO X7 250ie Service Station Manual

Engine

Removing the starter motor

- Remove the two screws indicated in the figure.
- Take the starter motor out of its seat
Removing the flywheel magneto
- Remove the water pump shaft and crankshaft
spline clip
- Line up the two holes in the flywheel as shown in
the photo
- Screw in the guide bushing that is part of the
special flywheel stop tool on the flywheel as shown
in the photo.
ENG - 26
Downloaded from www.Manualslib.com manuals search engine
X7 250ie