Crankcase - Crankshaft - PIAGGIO X7 250ie Service Station Manual

X7 250ie
Refitting the rocker-arms cover
- Refit the cylinder head cover, tightening the 5
clamping screws to the prescribed torque.
- Make sure the gasket is positioned properly.
Locking torques (N*m)
Tappet cover screws 6 - 7 Nm
Refitting the intake manifold
Fit the intake manifold and do up the three screws.
Locking torques (N*m)
Inlet manifold screws 11 ÷ 13

Crankcase - crankshaft

Splitting the crankcase halves
- Before opening the crankcase, it is advisable to
check the axial clearance of the crankshaft. To do
this, use a plate and a support with appropriate tool
dial gauge.
- Upper clearances are an indication of wear on
the surfaces of the crankshaft casing support.
- Remove the 10 crankshaft coupling screws.
- Separate the crankcase while keeping the crank-
shaft in one of the two halves of the crankcase.
- Remove the crankshaft.
- Remove the half crankcase coupling gasket.
Downloaded from www.Manualslib.com manuals search engine
Engine
ENG - 49