Decagon Devices AquaLab 4TE Operator's Manual page 29

AquaLab
5. Menus
ments memory, but only the fi nal reading will appear on the main
measurement screen. If AquaLab is connected to a computer using
AquaLink RG (See Chapter 11), all readings taken during a cus-
tom mode test will be downloaded to the AquaLink RG software.
On the mode screen, at the top of the page, will appear the current
mode settings with the number of tests appearing fi rst, followed by the
stability value (Δa ). Pressing enter with the custom mode highlight-
w
ed will allow the number of tests and stability settings to be changed.
To change the number of readings, use the right/left arrow but-
tons to highlight the number under Readings, and then use the
up and down buttons to change to any value between 2 and 9.
23