Connector Slots For Poe Daughter Card - IBM s-series Installation And User Manual

v Use the #2 Phillips-head or flathead screwdriver to loosen and remove the
two screws on the left and right ends of the 24-port module.
v Pull the card ejectors on the 24-port module toward you and away from the
module front panel. This action unseats the module from the backplane.
v Slide the module out of the chassis and place it on a static-free work area.
3. If you are replacing the POE daughter card, remove the existing card from the
connector slots on the 24-port module. Figure 41 on page 104 shows the
location of the POE daughter card.
4. Install the new POE daughter card:
v Locate the connector slots for the POE daughter card on the 24-port module
as shown in Figure 39.
Connector Slots
Figure 39. Connector slots for POE daughter card
5. Remove the POE daughter card from its packaging. The POE daughter card is
keyed to prevent improper insertion, as shown in Figure 40 on page 104.
Chapter 7. Maintaining the hardware
103