Table of Contents
Advertisement
be used with the LAN physical layer (PHY) and support optical monitoring
capabilities. Types of Brocade-branded SFP transceivers for the 100/1000 1 GbE
(SFP) interface modules include:
v 1000BaseT SFP Copper, 1 Gbps up to 100 m over CAT5 or higher cabling,
v 1000Base SX 850 nm SFP optic, 1 Gbps up to 550 m over multi-mode fiber, LC
v 1000Base LX 1310 nm SFP optic, 1 Gbps up to 10 km over single-mode fiber,
v 1000Base LHA 1550 nm SFP optic, 1 Gbps up to 70 km over single-mode fiber,
The slots support the 100Base and 1000Base fiber cabling listed in "Network
interfaces" on page 17.
Support for 100Base-FX on the 100/1000 interface module
The 24-port 100/1000 fiber interface module supports the 100Base FX 1310 nm
SFP optic, 100 Mbps up to 2 km over multi-mode fiber, LC connector.
To enable support for 100BaseFX, enter the CLI command at the interface level of
the CLI. For CLI command details, see the section regarding "Enabling and
Disabling Support for 100BaseFX" in the Configuration Guide.
2-port 10-Gigabit Ethernet interface modules
The 2-port 10-Gigabit Ethernet modules contain two physical ports, through which
you can connect the IBM device to other network devices at a speed of 10 Gigabits
per second.
Only supported Brocade-branded fiber-optic transceivers can be used in this
product. The XFP-compliant fiber-optic modules provide an optical transceiver or
physical medium dependent (PMD) interface for single or multi-mode fiber that can
be used with the LAN physical layer (PHY), and support optical monitoring
capabilities. Types of Brocade-branded XFP transceivers for the 10 GbE interface
modules include:
v Short Reach, 850 nm serial pluggable XFP optic, 10 Gbps up to 300 m over
v Long Reach, 1310 nm serial pluggable XFP optic, 10 Gbps up to 10 km over
v Extended Reach, 1550 nm serial pluggable XFP optic, 10 Gbps up to 40 km over
v 10 Base CX4, XFP transceiver, 10 Gbps up to 15 km, CX connector
Figure 10 shows the IPv4 2-port 10-Gigabit Ethernet module's front panel.
Figure 10. IPv4 2-port 10-Gigabit Ethernet module's front panel
16
Ethernet Switch s-series Installation and User Guide
RJ-45 connector
connector
LC connector
LC connector
multi-mode fiber, LC connector
single-mode fiber, LC connector
single-mode fiber, LC connector
1
42XG
Lnk
Act
2
Lnk
Act
Advertisement
Table of Contents
