Poe Daughter Card Key Detail - IBM s-series Installation And User Manual

Figure 40. POE daughter card key detail
Figure 41. Installing the POE daughter card
104
Ethernet Switch s-series Installation and User Guide
6. Insert the POE daughter card into the connector slot on the 24-port module as
shown in Figure 41.
7. Re-assemble the device:
v Gently slide the module back into the chassis until the ejectors on both
sides of the module move close to the module front panel.
v Push the ejectors in towards the center of the module. This action will fully
seat the module in the backplane.
v Use a #2 Phillips-head or flathead screwdriver to tighten the two screws at
both ends of the module front panel.
8. Observe the console. The following message will appear:
Info: PoE module detected in slot 1. Initializing....
9. Issue the show module command. The output should show the following
description for the 24-port module on which the POE daughter card is installed:
24-port Gig Copper + PoE