Removing An Original Power Supply; Original Power Supplies - IBM s-series Installation And User Manual

2. Disconnect the power cord from the chassis rear panel.
3. Use a Phillips-head or flathead screwdriver to loosen the latch retaining screw in
4. Gently pull on the power supply latch until the power supply is removed from
5. Install a new power supply in the slot. To read additional information about

Removing an original power supply

Figure 47. Original power supplies
To remove an original AC power supply, do the following:
1. Disconnect the power supply's power cord from the wall outlet.
2. Disconnect the power cord from the chassis rear panel.
3. Release the latch on the front of the power supply to unlock the power supply
Figure 48. Power supply removal
4. Gently pull on the power supply latch until the power supply is removed from
5. Install a new power supply in the slot. To read additional information about
the front upper right corner of the power supply. Once the screw is loosened,
the latch will spring gently forward and down.
the chassis.
performing this task, see "Installing a new power supply" on page 110.
EJE CT S YS
from its position in the chassis:
v Locate the 1/2" tab (latch release) on the bottom center of the front of the
power supply.
v Firmly press on the latch release.
v The latch should spring open.
v Gently push the latch to the right.
1.Push Latch Release In
the chassis.
performing this task, see "Installing a new power supply" on page 110.
2.Push Eject Latch to the Right
Chapter 7. Maintaining the hardware
EJE CT POE
3.Pull Power Supply Out
109