Step 2: Install The Mounting Hardware In A Four-Post Open Rack Or Open Cabinet - IBM J02M Quick Start Manual

IBM Ethernet Router J02M Quick Start

Step 2: Install the Mounting Hardware in a Four-Post Open Rack or Open Cabinet

To install the mounting shelf on the front rails of a four-post open rack or open
cabinet, or the rails of an open-frame rack:
1.
2.
3.
4.
5.
Table 1: J02M Mounting Hole Locations
8
Step 2: Install the Mounting Hardware in a Four-Post Open Rack or Open Cabinet
If needed, install cage nuts in the holes specified in Table 1 on page 8.
On the back of each rack rail, partially insert a mounting screw into the lowest
hole specified in Table 1 on page 8.
Install the mounting shelf on the back of the rack rails. Rest the bottom slot of
each flange on a mounting screw.
Partially insert screws into the open holes in each flange of the mounting shelf
(see Figure 2 on page 9 or Figure 3 on page 10).
Tighten all the screws completely.
Hole Distance Above U Division
4 2.00 in. (5.1 cm)
3 1.51 in. (3.8 cm)
2 0.88 in. (2.2 cm)
1 0.25 in. (0.6 cm)
Mounting Shelf
1.14 U
X
0.86 U
X
0.50 U
X
0.14 U
X